Announcing a new Tell us what you think and help shape the future
Federal Communications Commission Logo - Click here to go to the FCC home page

Universal Licensing System

Skip Section Navigation Links ULS Logo

North American Datum of 1983 Coordinates

Converting Coordinates

Geographic coordinates provided to the Commission via the Universal Licensing System must be referenced to the North American Datum of 1983 (NAD83). If the source from which you obtain the coordinates is referenced to another datum (e.g., NAD27, PRD40) you must convert the coordinates to NAD83.

The FCC uses the procedures outlined below when converting licensing data to NAD83 coordinates when a radio service is converted to the Universal Licensing System (ULS). In most cases, this procedure uses the NADCON software developed by the National Geological Survey. For certain Pacific island areas, the FCC uses a specified shift from the applicable local datum. For other Pacific island areas where a conversion is not yet available, coordinates should continue to be referenced to the applicable local datum.

Applicants and licensees who need to submit NAD83 coordinates to the Commission should use the conversion procedures outlined below:

Procedure for Converting Coordinates to NAD83

Methods of conversion. Sort the site data by state/territory and take the action listed below. Near-offshore sites and sites in the Gulf of Mexico are converted as part of the nearest state/territory.

Location Action
Convert using NADCON
CONUS (i.e., the contiguous 48 states and the District of Columbia)
Alaska (including St. Laurence, St. George, and St. Paul Islands)
Puerto Rico
U.S. Virgin Islands
Convert to NAD83 using NADCON software

This software is available at See NADCON software section below.)
Convert using Specialized Methods
American Samoa Convert to NAD83 using Method #1 below
Guam Convert to NAD83 using Method #2 below
Do Not Convert
Baker Island
Howland Island
Jarvis Island
Johnston Island
Kingman Reef
Midway Island
Northern Mariana Islands
Palmyra Island (Atoll of Palmyra)
Wake Island
Do not convert to NAD83; coordinates remain in local datum

NADCON Software

Conversion must be done using Version 2.0 or Version 2.1 of the NADCON software. Interactive NADCON software is available at

The following chart summarizes the input parameters of the NADCON software. All other latitude/longitude combinations are "out of bounds" (i.e. too far offshore) and cannot be converted using the NADCON software because NAD83 is not applicable to these sites.

  Latitude (degrees) Longitude (degrees)
Location min latitude max latitude min longitude max longitude
CONUS 20 50 63 131
Hawaii 18 23 154 161
Puerto Rico and USVI 17 19 64 68
AK - St. Laurence Island 62 64 168 172
AK - St. George Island 56 57 169 171
AK - St. Paul Island 57 58 169 171
Alaska 46 77 128 194

Method #1

For the unincorporated territory of American Samoa.

The following datum shift converts coordinates referenced to the American Samoa Datum of 1962 to NAD83. Determine on which island the site is located and perform the conversion as follows:

For Tutuila Island
lat, long (NAD83) = lat - 17.83406", long + 4.37866"

For the Manua Islands
lat, long (NAD83) = lat - 18.32515", long + 4.43134"

Method #2

For the unincorporated territory of Guam.

The following datum shift converts coordinates referenced to the Guam 1963 datum to NAD83. Perform the conversion as follows:

lat, long (NAD83) = lat + 5.15932", long + 8.71596"

NOTE for the above methods: The FCC previously provided these datum shift coordinates rounded to two decimal places. ULS will record latitude and longitude to the tenths. We are providing the coordinate data as supplied by NGS for the benefit of licensees and applicants whose source data may consist of more than two significant digits.

Sources: The conversion information below was supplied by the National Oceanic and Atmospheric Administration, National Geodetic Survey's internet website,, and Mr. David Doyle of the NGS's Observation and Analysis Division.

Additional Data Conversion Resources

In addition to the Internet-driven NADCON software, the National Geological Survey provides software that you may download from its website at:

In 1990, the Federal Geodetic Control Committee adopted the method employed by the NADCON software as the federal standard for the conversion to NAD83. See Notice to Adopt Standard Method for Mathematical Horizontal Datum Transformation, 55 Fed. Reg. 32681-01. We will add links to other resources as they become available and are tested by the FCC and NGS for compliance with this standard. If you are aware of other resources that may be useful in this regard, please email us.

If you have any comments or questions about this information, please contact Technical Support.

Last reviewed/updated on